Semiconductor
Connector
- φ50 Bar Material SUS 303
Precision Valve
- φ50 Bar Material SUS 303
Connector
- φ40 Bar Material SUS 303
Valve
- φ50 Bar Material SUS 303
Joint
- φ50 Bar Material SUS 303
Case
- φ50 Bar Material SUS 303
Diameter | φ50 |
Material | Bar Material SUS 303 |
Point Bar material is machined into block shapes using three turrets equipped with Y-axis and milling capabilities. Additionally, various technologies are incorporated to shorten cycle times, including high-speed milling and drilling at up to 10,000 rpm, high-speed rigid tapping at 8,000 rpm, and Chronocut to reduce idle time.
Click to play video
- NTY3-100V Max. turning diameter:200mm Distance between spindles:820mm
Diameter | φ50 |
Material | Bar Material SUS 303 |
Point The swivel B-axis turret allows for the machining of angled holes with different orientations using a single tool. Additionally, being a turret machine, it enables rapid tool changes, facilitating efficient machining.
Click to play video
- NTJ-100 Max. turning diameter:175mm Distance between spindles:910mm
Diameter | φ40 |
Material | Bar Material SUS 303 |
Point By using a three-turret machine, process optimization is achieved, enabling machining at the smallest size suitable for small workpieces.
Click to play video
Diameter | φ50 |
Material | Bar Material SUS 303 |
Point Simultaneous machining with three turrets streamlines the process and reduces cycle time. Additionally, simultaneous upper and lower milling enables the machining of complex shapes, allowing for complete processing from bar material to finished product with a single machine.
Click to play video
- NTY3-250 Max. turning diameter:225mm(op.191mm) Distance between spindles:1,200mm
Diameter | φ50 |
Material | Bar Material SUS 303 |
Point Efficiently milling block-shaped workpieces from bar material achieves advanced milling capabilities comparable to those of a machining center.
Click to play video
Diameter | φ50 |
Material | Bar Material SUS 303 |
Point Milling from bar stock and simultaneous processing of square shapes using both the upper and lower Y-axes have been achieved.
Click to play video